c) Redistributes a range of values into a new set of categories and creates a. I like to keep my original variables, so tend to use the INTO option to recode into a new variable. What is the advantage of using SPSS over calculating statistics by hand. So if you are using SPSS in the year 2020, it will assume that the century range is 1951 to 2050 but if you open SPSS a year later, SPSS will assume that the century range is 1952 to 2051.

T-statistic for the difference between the two means and the significance. The difference between the average amount of support provided to mothers and fathers and accompanying standard deviation. If we didnвЂ™t include the вЂњ into bmicatвЂќ at the end of the syntax, we would recode the original bmiВ variable and would lose the individual BMI values and replace them with categories. The default century range in SPSS is based on the current year: it will start the range at 69 years prior to the current year and end the range at 30 years after the current year. SPSS also gives the correlation between the two dependent variables, that was left off here for space. We are recoding the bmiВ variable INTO a new variable, bmicat. range of higher values, such that the distribution of a variable that is very skewed with a long. We also tell SPSS that any data that were missing (sysmis) we want to be missing in our new recoded variable. This might be an SPSS file with all the data properly. The recode command is followed by the variable name ( bmi), then we put in brackets the value ranges for each category, and give them a label (1, 2, 3, and 4 for the four categories). Here is the code to write in your syntax: Now that we have our new variable BMI, we want to recode it into a new variable, bmicat, where the BMI values are categorised into underweight (BMI=18.5 and =25 and =30).

Spss code range